ViCare Climate Sensor and ViCare Repeater: Information on using the device
Installation & operating instructions
Depending on the type of power supply, the device can be operated as a climate sensor or as a repeater.
ViCare Climate Sensor
In battery mode, the device works as a sensor for room temperature and humidity. It can only be used in conjunction with a heat generator with Viessmann One Base or Vitoconnect (OPTO2 or higher) as an internet interface. Stand-alone use is not possible.
ViCare Repeater
When operated with the supplied plug-in power supply unit, the device works as a repeater. It then increases the range of the low-power radio via which the ViCare devices communicate with each other.
Please note: If the device was already registered as a ViCare Repeater, i.e. with a plug-in power supply unit, and you want to use it as a climate sensor or vice versa, you must first reset it to the factory setting. You must then reprogram the device using the ViCare app.
Further information:
- In these cases, the use of a ViCare Repeater is recommended.
- This allows you to use ViCare Repeaters to ensure optimum signal strength for the operation of your ViCare Radiator Thermostats.
Please give us your feedback!
Your feedback is very important to us, as it helps us better understand your needs and continuously improve our services. By sharing your experience, you contribute directly to making our solutions more useful and effective for you and other users.
Submit your feedback by clicking the button.
Error
We are currently unable to process your submit. Please try again later
